We need your help! 🔥
Please consider disabling your ad-blocker to support this website! 🔑
We are a free, community-supported website! 🥰
We only display small unobtrusive ads which help us stay online! 💯
Thank you in advance! ❤️
We are a free, community-supported website! 🥰
We only display small unobtrusive ads which help us stay online! 💯
Thank you in advance! ❤️
Print Curve - Filament
Converts a curve into g code to 3D print with a standard filament based printer
Inputs
| Name | ID | Description | Type |
|---|---|---|---|
| Curve Geometry | Crv | input curve to trace | Curve |
| Primary config for 3DP_F | C | Optional configuration for 3D printing with filament. Direct entries will override these config entries. | Goo |
| start and end g code | SE | Boolean input to determine wether or not to add the start and end g code needed to intiate and end a print. You may also adda customized start and end gcode sequences from the Start G Code and the End G Code components. | Goo |
Outputs
| Name | ID | Description | Type |
|---|---|---|---|
| G Code | GC | Complete g code for printing a single wall model with no infill | Goo |
| Point | Pt | Contains a collection of three-dimensional points | Point |
| Printer Lines as polylines | Pl | polyline describing the path traveled by the printer. | Curve |
| Total Filament Extruded (mm) | F | estimate of the total amount of filament needed to complete this section of g code | Goo |
Site design © Robin Rodricks.
Xylinus and associated data © 2024 Ryan Hoover.
Rhinoceros and Grasshopper are registered trademarks of Robert McNeel & Associates.
Hosted by GitHub