We need your help! 🔥
Please consider disabling your ad-blocker to support this website! 🔑
We are a free, community-supported website! 🥰
We only display small unobtrusive ads which help us stay online! 💯
Thank you in advance! ❤️
Core
DLP
Filament
Syringe

Print Curve with Infill - Syringe

Slices input geometry and renerates G Code to print [W] walls and infill at [I] density. Works for simple or complex geometries.


a W# walled form without any infil or top/bottom layers. For standard filament printing.

Inputs

NameIDDescriptionType
CurveCrvContains a collection of generic curvesCurve
Primary config for 3DP_FCOptional configuration for 3D printing with filament. Direct entries will override these config entries.Goo
Perimenter Wall CountWnumber of solid perimeter walls to printInteger
Infill Ratio (0-1)ISet the density of the infill from 0 (none) to 1 solid).Number
Z ClearanceZCContains a collection of floating point numbersNumber
start and end g codeSEBoolean input to determine wether or not to add the start and end g code needed to intiate and end a print. You may also adda customized start and end gcode sequences from the Start G Code and the End G Code components.Goo

Outputs

NameIDDescriptionType
G CodeGCComplete g code for printing a single wall model with no infillGoo
Printer LinesPlpolylines representing the travel paths to be printedCurve
PointPtContains a collection of three-dimensional pointsPoint
PolylinePlConverted curveCurve

Site design © Robin Rodricks.   Xylinus and associated data © 2024 Ryan Hoover.  
Rhinoceros and Grasshopper are registered trademarks of Robert McNeel & Associates.  Hosted by GitHub

Report an Issue  |  Terms of Service