We need your help! 🔥
Please consider disabling your ad-blocker to support this website! 🔑
We are a free, community-supported website! 🥰
We only display small unobtrusive ads which help us stay online! 💯
Thank you in advance! ❤️
We are a free, community-supported website! 🥰
We only display small unobtrusive ads which help us stay online! 💯
Thank you in advance! ❤️
Print Curve with Infill - Filament
Slices input geometry and renerates G Code to print [W] walls and infill at [I] density. Works for simple or complex geometries.
a W# walled form without any infil or top/bottom layers. For standard filament printing.
Inputs
| Name | ID | Description | Type |
|---|---|---|---|
| Curve | Crv | Contains a collection of generic curves | Curve |
| Primary config for 3DP_F | C | Primary configuration for 3D printing with filament | Goo |
| Perimenter Wall Count | W | number of solid perimeter walls to print | Integer |
| Infill Ratio (0-1) | I | Set the density of the infill from 0 (none) to 1 solid). | Number |
| start and end g code | SE | Boolean input to determine wether or not to add the start and end g code needed to intiate and end a print. You may also adda customized start and end gcode sequences from the Start G Code and the End G Code components. | Goo |
Outputs
| Name | ID | Description | Type |
|---|---|---|---|
| G Code | GC | Complete g code for printing a single wall model with no infill | Goo |
| Printer Lines | Pl | polylines representing the travel paths to be printed | Curve |
| Point | Pt | Contains a collection of three-dimensional points | Point |
| Total Filament Extruded (mm) | F | Result of mass addition | Goo |
Site design © Robin Rodricks.
Xylinus and associated data © 2024 Ryan Hoover.
Rhinoceros and Grasshopper are registered trademarks of Robert McNeel & Associates.
Hosted by GitHub