Grasshopper Docs

Community documentation for Grasshopper add-ons & plugins

Analysis
Data
Display
Gems
Jewelry
Production
Profiles
Rings
Workbench

Make a embossment on a surface

Inputs

NameIDDescriptionType
SurfaceSrfBase surfaceSurface
GeometriesGeoGeometries to make the embossing. Note that each control point assumes the distance to the closest geometry and must be less than the input radius.GeometricGoo
ResolutionResResolution of control points in proportion to the unit of space. Resolution 2.0 on a surface of 5 x 6 units, will give 10 x 12 control points. Set 0 to keep the control points of the input surface. Note that this value should be high enough for the embossment to have resolution, but low enough to be computationally manageable.Number
HeightHgtElevation or height for each input geometry. Note that moving the control points, it is possible that the actual height of the surface is different.Number
RadiusRadMargin or radius of influence for each input geometry, from which embossing will begin at control points that are within this distance.Number
FactorsFacList of normalized values (between 0 and 1) to define the contour shape of the embossmentNumber

Outputs

NameIDDescriptionType
SurfaceSResulting surfaceSurface

Video Tutorials

Site design © Robin Rodricks.   Peacock and associated data © 2022 Daniel Gonzalez Abalde.  
Rhinoceros and Grasshopper are registered trademarks of Robert McNeel & Associates.  Hosted by GitHub

Report an Issue  |  Terms of Service