Grasshopper Docs

Community documentation for Grasshopper add-ons & plugins

1.Model
2.Load
3.Cross Section
4.Material
5.Algorithms
6.Results
7.Export
8.Utilities
License

Add hinges at the end-points of beams.

Inputs

NameIDDescriptionType
Element IdentifiersElemIdsList of identifiers of beams to attach joint toString
Ct [kN/m] at starting-nodeCt-startTranslational spring stiffness [kN/m] at starting-node of beam.Values take effect if corresponding DOF is set to hinge.Vector
Cr [kNm/rad] at starting-nodeCr-startRotational spring stiffness [kNm/rad] at starting-node of beam.Values take effect if corresponding DOF is set to hinge.Vector
Ct [kN/m] at end-nodeCt-endTranslational spring stiffness [kN/m] at end-node of beam.Values take effect if corresponding DOF is set to hinge.Vector
Cr [kNm/rad] at end-nodeCr-endRotational spring stiffness [kNm/rad] at end-node of beam.Values take effect if corresponding DOF is set to hinge.Vector
Dofs-startDofs-startList of degree of freedom indexes (0:tx, 1:ty, 2:tz, 3:rx, 4:ry, 5:rz) to be released at starting-node in addition to those selected via check-boxes.Integer
Dofs-endDofs-endList of degree of freedom indexes (0:tx, 1:ty, 2:tz, 3:rx, 4:ry, 5:rz) to be released at starting-node in addition to those selected via check-boxes.Integer

Outputs

NameIDDescriptionType
JointJointDefinition of a joint.Joint

Video Tutorials

Site design © Robin Rodricks.   Co-created by Andrew Heumann.   Karamba3D and associated data © 2022 Clemens Preisinger.  
Rhinoceros and Grasshopper are registered trademarks of Robert McNeel & Associates.  Hosted by GitHub

Report an Issue  |  Terms of Service