Split Floor2Thermal Zones

Use this component to divide up a brep (polysurface) representative of a building floor into smaller volumes that roughly correspond to how a generic EnergyPlus model should be zoned.
This zoning divide up each floor into a core and perimeter zones, which helps account for the different microclimates you would get on each of the different orientations of a building.
Note: This component is intended mainly for convex geometry. Most concave geometries will fail, and any shapes with holes in them will fail. You should therefore prepare the
massing of your building by dividing it into convex volumes before using this component.
If you have a single mass representing two towers off of a podium, the two towers are not a continuous mass and you should therefore send each tower and the podium in as a separate Brep into this component.
Core and perimeter zoneing should work for almost all masses where all walls are planar.
While this component can usually get you the most of the way there, it is still recommended that you bake the output and check the geometry in Rhino before turning the breps into HBZones.
The assumption about an E+ zone is that the air is well mixed and all at the same temperature.
Therefore, it is usually customary to break up a building depending on the areas where you would expect different building microclimates to exist.
This includes breaking up the building into floors (since each floor can have a different microclimate) and breaking up each floor into a core zone and perimeter zones (since each side of the buidling gets a different amount of solar gains and losses/gains through the envelope).
This component helps break up building masses in such a manner.

Inputs

Outputs

Video Tutorials